SCHRS MEASUREMENT
New ratings for the 2013 season have recently been approved by the SCHRS World Council. We are busy this page and expect the new information to appear in a few days.
Beam Measurements
- Beam - Width of the beam *
* The maximum width of the boat, including wings, racks, sliding seats or other appendages.
Boards Measurements
- Standard daggerboard where VLB = board depth below hulls (a)
- T Foil daggerboard where VLB = addition of both lengths (b + c)
- Curved daggerboard where VLB = measured around external circumference (d)
Main Sail Measurements
CM - Area of Main Sail + Mast + Boom
- S1 = ((h + h1)(a - a1) + (a1 x h))/2
- S2 = c x h2/2
- S3 = 2/3 c3 x h3
- S4 = c4 x h4/2
- S5 = 2/3 c5 x h5
- S6 = 2/3 c6 x h6
- S7 = 2/3 a x h7
- S8 = 2/3 b x h8
- CM* = (S1+S2+S3+S4+S5+S6+S7+S8)m²
- Area of Mast0 = (Total Length x Perimeter / 2)m²
- Area of Boom1 = (Total Length x Height)m²
- CM = (CM* + Area of Mast + Area of Boom)m²
* intermediate calculation if other conditions apply
0 only applies to rotating masts
1 does not apply to boomless sails or if height is greater than 1.5 of breath
LTM Length of Top of Mainsail
Jib Measurements
CJ - Area of Jib
- S9 = a x h / 2
- S10 = 2/3 b x h10
- S11 = 2/3 c x h11
- S12 = 2/3 a x h12
- CJ = ( S9 +or- S10 +or- S11 +or- S12 ) m²
Spinnaker Measurements
CSPI - Area of Spinnaker
- CSPI = SFx(SL1+SL2)/4+(SMG*-SF/2)x2/3(SL1+SL2)/2 m²
* where SMG >= 75% of SF
Basic Boat Measurements
* Including Rotating Masts and Boom, when applicable.